![]() ![]() Hold the X-axis motor shaft with pliers (take advantage of the flat part of the shaft) and try to move with the extruder. Use the technique described in this step of the assembly manual to test if the pulley is correctly tightened and if the belt is not too loose. The plastic parts holding the belts can get loose over time. It should be possible to pinch the two sides together with your thumb and index finger, but you should feel a little bit of resistance. The clue we can give you is that the belt should sound roughly like a low bass string when plucked. The MK2.5S, MK2.5, and lower models do not have the belt status option. The values are updated every time you run the Selftest or run the belt test in LCD menu -> Calibration -> Belt test.If your value over (or close to) 300, you need to tighten the belt. ![]()
0 Comments
Leave a Reply. |